Czech Republic - Libcice - Tursko (GFS 27 km 21.07. 12 UTC)
logo Su
21.
Su
21.
Su
21.
Mo
22.
Mo
22.
Mo
22.
Mo
22.
Mo
22.
Tu
23.
Tu
23.
Tu
23.
Tu
23.
Tu
23.
We
24.
We
24.
We
24.
14h 17h 20h 08h 11h 14h 17h 20h 08h 11h 14h 17h 20h 08h 11h 14h
Wind speed (m/s) 3.2 3.9 2.6 1 1.1 2.8 3.2 3.2 1.7 2.1 2.5 2.6 2.3 0.5 1.7 2.1
Wind gusts 4.7 5.3 4.1 1.3 2.1 4.1 4.6 6.4 2.4 2.6 3.3 3.6 3.3 0.6 2 2.1
Wind direction WNW WNW W WSW WSW WNW NW N WNW NNW NNW N NNE NE E ENE
Temperature (°C) 24 24 21 18 23 25 26 22 19 23 26 28 24 20 25 28
Rain (mm/3h) - 0.8 1.3                          
28.06.2010 19:12 Age: 9 yrs

NOTE !!! Veryfied method of binding ASSAN X8F module on FUTABA T10CP !!!

After several experiments with binding, receivers and transmitter module Assan X8F on system FUTABA T10CP I think I found a repeatable functional procedure. Read on ...

Probably this is related to the FUTABA T10CP system or wrong instructions that I got, who knows. In any case, repeatable, functional procedure is as follows:

  • Plug the connector into the signal pins of channel 1 and 3
  • Turn on the transmitter and before the transmitter module beep, push the throtle up (3th channel !) to full throtle. LED on transmition module and blue LED on system starts blink. The TX module and system will beep.
  • Turn the power of receiver.
  • Within a few seconds LEDS stop flashing and the receiver and transmitter is permanently light green LED. It is done.

This process I repeated several times with all four Assan receivers and it have always works flawlessly.

Against the original manual is a difference in moving the channel 3, instead of the channel 2 as manual said, and just move with it just once. Must catch it before transmitting module will operate normally, then before you hear the long tone of the module and the blue LED lights on the system and the green on transmitter module.